書誌事項
- タイトル別名
-
- Laboratory Verification of the Diametrical Core Deformation Analysis (DCDA) Developed for In-situ Rock Stress Measurements
- コア ヘンケイホウ(DCDA)ノ シツナイ ケンショウ ジッケン
この論文をさがす
抄録
DCDA is a new method for evaluating the in-situ stress of rocks based on the elliptical deformation of boring cores with stress relief. If the condition of in-situ stress is anisotropic, the core must expand elastically in an asymmetric shape. The cross sectional shape of the expanded core can be measured precisely, and the differential stress SHmax<tt>-</tt>Shmin and azimuths of SHmax and Shmin can be determined from the measured shape data. In order to confirm the reliability of DCDA, laboratory verifications were conducted focusing on a manner how the core expands with stress relief caused by drilling.We used 300 mm cube mortar specimens in which strain gages were embedded.The specimen was set into a steel frame where it was subject to an uniaxial compressive stress using a pair of flat jacks. While holding the applied stress, a core sample was drilled out from the specimen and the strain in the core was recorded. Following results are obtained; 1) The relief strain caused in the core has the same magnitude with the strain in the specimen caused by applying a uniaxial compressive stress, while those strains are opposite in sign. 2) The experimentally-observed core expansion with drilling was consistent with that predicted by a linear elastic FEM. 3) Some core bits may scrape partially the surface of the expanded core, then DCDA will underestimate the applied stress. A specially-designed core bit must be necessary for DCDA to avoid scraping the expanded core.
収録刊行物
-
- 資源と素材
-
資源と素材 130 (12), 515-521, 2014
一般社団法人 資源・素材学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680257440256
-
- NII論文ID
- 130005113082
-
- NII書誌ID
- AA12188381
-
- ISSN
- 18840450
- 18816118
-
- NDL書誌ID
- 025959516
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可