Improvement of crystallinity and surface roughness in epitaxial CeO<sub>2</sub>/Ce<sub>1&minus;</sub><i><sub>x</sub></i>Zr<i><sub>x</sub></i>O<sub>2</sub>/Y<sub>0.15</sub>Zr<sub>0.85</sub>O<sub>1.93</sub> buffer layers deposited on a Si(100) substrate by pulsed laser deposition

DOI Web Site 参考文献9件 オープンアクセス
  • AIHARA Wataru
    Department of Metallurgy and Ceramics Science, Tokyo Institute of Technology
  • SHIOTA Tadashi
    Department of Metallurgy and Ceramics Science, Tokyo Institute of Technology
  • SAKURAI Osamu
    Department of Metallurgy and Ceramics Science, Tokyo Institute of Technology
  • SHINOZAKI Kazuo
    Department of Metallurgy and Ceramics Science, Tokyo Institute of Technology

書誌事項

タイトル別名
  • Improvement of crystallinity and surface roughness in epitaxial CeO<sub>2</sub>/Ce<sub>1−</sub><i><sub>x</sub></i>Zr<i><sub>x</sub></i>O<sub>2</sub>/Y<sub>0.15</sub>Zr<sub>0.85</sub>O<sub>1.93</sub> buffer layers deposited on a Si(100) substrate by pulsed laser deposition

この論文をさがす

説明

Epitaxial CeO2/Ce1−xZrxO2/Y0.15Zr0.85O1.93 (YSZ) buffer layers were fabricated on a Si(100) substrate by pulsed laser deposition, and its crystallinity and surface roughness were analyzed. When Ce1−xZrxO2 (x = 0–0.6) films were directly deposited on the Si(100) substrate, the films had a (111) or (111)-preferred orientation. In contrast, (100)-oriented epitaxial films of the Ce1−xZrxO2 (x = 0–0.6) were obtained by introducing a 2.5-nm-thick YSZ buffer layer between Ce1−xZrxO2 and Si. Lattice parameters and surface roughness of the Ce1−xZrxO2 layers on the YSZ-buffered Si(100) decreased from 0.542 to 0.525 nm (in-plane) and 0.47 to 0.12 nm, respectively, as the increase of x from 0 to 0.6. After that, an epitaxial CeO2/Ce0.4Zr0.6O2/YSZ buffer layer was fabricated on the Si substrate. Differences in lattice parameters between CeO2 and Ce0.4Zr0.6O2 and also between Ce0.4Zr0.6O2 and YSZ became about half of that between CeO2 and YSZ. As a result, surface roughness of the CeO2 layer on top of the Ce0.4Zr0.6O2/YSZ/Si and full width at half maximum of the rocking curve of the CeO2 (004) reflection became 0.18 nm and 0.89 degrees, respectively, which were smaller than those of CeO2 layers deposited directly on YSZ/Si.

収録刊行物

参考文献 (9)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ