書誌事項
- タイトル別名
-
- Outgassing Rate Measurement of the Plastics
- ゴウセイ ジュシ オ モチイタ ザイリョウ ノ キタイ ホウシュツ ソクド ソクテイ
この論文をさがす
抄録
Since materials of plastomer materials of synthetic resin have a large outgassing rate than metals, they are not so suitable for use as uhv components. However, some of the plastomers are often installed in vacuum system, where their low electrical- and thermal-conductivity are required. The outgassing rates were measured for bulk samples of FRP, PEEK and polyimide, and for thin sheets of PET (Aluminum deposited PET film of 9 μm thick.) and polyimide. The outgassing rate is decreased in a manner of t−1/2, indicating diffusion process of absorbed gas molecules from bulk. The rate of sheet, being after several tens hour pumping, shows rapid decrease. The effect of bake-out degassing in vacuum is also examined for bulk plastomers.<br>
収録刊行物
-
- Journal of the Vacuum Society of Japan
-
Journal of the Vacuum Society of Japan 56 (10), 422-424, 2013
一般社団法人 日本真空学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680272993664
-
- NII論文ID
- 10031202145
-
- NII書誌ID
- AA12298652
-
- BIBCODE
- 2013JVSJ...56..422S
-
- COI
- 1:CAS:528:DC%2BC3sXhvFakt7zM
-
- ISSN
- 18824749
- 18822398
-
- NDL書誌ID
- 024944342
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可