粒度の異なる珪砂を用いたモルタルの押出成形特性についての実験的検討

DOI Web Site

書誌事項

タイトル別名
  • Experimental investigation on extrusion characteristics of mortars prepared from various size silica sand aggregates.
  • リュウド ノ コトナル ケイサ オ モチイタ モルタル ノ オシダシ セイケイ

この論文をさがす

抄録

Extrusion characteristics are intimately associated with the product properties of building materials. In this paper, both extruding pressure and extruding velocity were measured to investigate the extrusion characteristics of mortars. The mortars were prepared from fine silica sand aggregates of various sizes (6 kinds of silica sand and standard sand) and had different water contents.<br>The water content ratio which resulted in good surface appearance of moulding was little higher for the fine aggregates than for the coarse ones. The extruding pressure dropped abruptly with an increase of water content ratio. The extruding velocity increased with increasing water content ratio. The upward trend of extruding velocity declined at high water content ratio. The water content ratio had much more influence on extruding pressure and velocity than the grading of aggregates had.<br>In the cases of organic thermoplastics and clay like ceramics, the extruding pressure and velocity have been known to be prescribed by the extruder operating point determined by a cross point of screw characteristics and die characteristics. It seems to be possible to apply this operating point concept to the extrusion of mortar.

収録刊行物

  • 材料

    材料 36 (410), 1279-1283, 1987

    公益社団法人 日本材料学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ