フラクトグラフィによる機械部品の疲労破損解析

DOI Web Site

書誌事項

タイトル別名
  • Fatigue failure analysis of machine parts by means of fractography.
  • フラクトグラフィ ニ ヨル キカイ ブヒン ノ ヒロウ ハソン カイセキ

この論文をさがす

抄録

Failure analysis for a reduction gear and bolts failed by fatigue was carried out by means of fractography, and the values of stress amplitude during service were estimated using a relation between striation spacing and stress intensity factor range, ΔK. The failed reduction gear had been used for a hoist with a rated load of 5 tonf attached to a travelling crane, and fatigue cracks initiated from the root of teeth. The bolts had been used for connection of slewing circle and counter weight of a truck crane. Metallurgical examination, fatigue test and calculation of applied stress were also performed to clarify the failure causes. The stress distributions of 32 high strength bolts of 20mm diameter on a slewing circle were measured by strain gauges mounted on the bolts, and the measurement was carried out using the same type of track crane as the failed one.<br>The value of stress amplitude evaluated from the striation spacing was found to be almost equal in stress to that of the result of calculation or actual measurement of stress. Therefore the combined fractographic-fracture mechanics method was found very valuable in the quantitative analysis of fatigue failure of machine parts. The failure cause of the gear was related to the lack of hardness of tooth root. The fatigue limit of the bolts was 4.8kgf/mm2. The couse of failure for the bolts was due to overload during operation. Moreover, a high stress concentration for few bolts in the slewing circle may also be related to the failure cause.

収録刊行物

  • 材料

    材料 36 (404), 431-436, 1987

    公益社団法人 日本材料学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ