赤外線サーモグラフィによるプリント基板のマイクロドリル加工現象のモニター　－アラミド繊維強化基板の加工時のドリル温度について－

DOI Web Site 被引用文献6件 参考文献9件

書誌事項

タイトル別名
  • Monitoring of Micro Drilling of Printed Wiring Boards by Thermograph-Drilling Temperature of Printed Wiring Boards Reinforced by Aramid Fiber-
  • セキガイセン サーモグラフィ ニ ヨル プリント キバン ノ マイクロドリル カコウ ゲンショウ ノ モニター アラミド センイ キョウカ キバン ノ カコウジ ノ ドリル オンド ニ ツイテ
  • Drilling Temperature of Printed Wiring Boards Reinforced by Aramid Fiber
  • アラミド繊維強化基板の加工時のドリル温度について

この論文をさがす

抄録

In the current manufacture of multi-layer printed wiring boards, AFRP (Aramid Fiber Reinforced Plastices) has been attracted attention, because of its low coefficient of linear thermal expansion in the x-y plane and of good machinability of CO2 laser. However, there are few reports dealing with drilling of AFRP printed wiring boards. Therefore, this paper describes the small diameter drilling of AFRP printed wiring boards. First, the temperature of drill tools was monitored by infrared thermography. Second, the drilled hole walls were observed by SEM and optical microscope. Comparing with them, it is clear that the drilled hole quality depend on the drill tool temperature in drilling. Additionally, it is confirmed that the increase of drill temperature is due to the heat caused by friction between the drill tool and drilled hole wall.

収録刊行物

  • 材料

    材料 53 (5), 553-559, 2004

    公益社団法人 日本材料学会

被引用文献 (6)*注記

もっと見る

参考文献 (9)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ