書誌事項
- タイトル別名
-
- Influence of Measurement Conditions on the Accuracy of Measured Stress Using X-ray 2D Detector
- 2ジゲン Xセン ケンシュツキ ニ ヨル オウリョク ソクテイ セイド ニ オヨボス ソクテイ ジョウケン ノ エイキョウ
この論文をさがす
抄録
For the X-ray stress measurement in the region which has a steep stress gradient such as the neighborhood of a crack, a smaller irradiation area is required to estimate highly precise stresses. However, the reduction of the irradiated area brings a decrease in diffraction intensity and spotty diffraction pattern. In the conventional X-ray stress measurement using a scintillation counter, 1000 grains within the irradiated area and the oscillation method are recommended. However, for the sin2ψ method using a two-dimensional detector, effect of measurement conditions is not clear yet. In the present study, the effects of the oscillation condition and irradiated area on the accuracy of the stress measured by the sin2ψ method were investigated. For the oscillation effect, θ angle was more effective than χ angle. For the two-dimensional detector, the decrement of the number of grains required for accurate stress determination corresponded to the increase of the area of the detector. The stress distribution near a crack was able to be measured with the collimator diameter of 0.3 mm or more with enough accuracy for 2024-T3. It was suggested that actual stress could be evaluated by the reverse analysis of measured average stresses.
収録刊行物
-
- 材料
-
材料 63 (7), 521-526, 2014
公益社団法人 日本材料学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680420569472
-
- NII論文ID
- 130004481116
-
- NII書誌ID
- AN00096175
-
- ISSN
- 18807488
- 05145163
-
- NDL書誌ID
- 025632083
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可