Selection of active effects based on a ridge regression in supersaturated response surface designs
-
- Matsuura Shun
- Keio University
-
- Tajima Shogo
- Yokohama Plant, NISSAN MOTOR CO.,LTD.
-
- Suzuki Hideo
- Keio University
説明
<p>Response surface method has been a commonly used statistical method for quality improvement. As the importance of short-term and low-cost product development becomes higher nowadays, conventional response surface designs may need too large number of experimental runs to be accepted. Recently, supersaturated response surface designs were constructed by using several columns of Hadamard matrices (two-level orthogonal arrays), which considerably reduce the number of experimental runs, and a stepwise regression based on -tests was applied to their data analysis. In this paper, a criterion is introduced for constructing supersaturated response surface designs, and a ridge regression is used for the data analysis of supersaturated response surface designs. Several comparisons through numerical simulations are also presented.</p>
収録刊行物
-
- Total Quality Science
-
Total Quality Science 2 (1), 1-11, 2016
一般社団法人 日本品質管理学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282680740257664
-
- NII論文ID
- 130005167409
-
- DOI
- 10.17929/tqs.2.1
-
- ISSN
- 21893195
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可