サンドブラスト加工条件の最適化による薄板セラミックスの加工クラック抑制

書誌事項

タイトル別名
  • Avoiding Processing Cracks in Thin Ceramic Plates by Optimization of Sand Blasting Conditions
  • サンドブラスト カコウ ジョウケン ノ サイテキ カ ニ ヨル ハクバン セラミックス ノ カコウ クラック ヨクセイ

この論文をさがす

抄録

<p>Devices made by processing a thin lead zirconate titanate ceramic plate are used in the ink droplet firing units of ink-jet printers. The desired device shape is obtained by sand blasting the thin ceramic plate, but the formation of cracks in the thin ceramic plate during the sand blasting process has been a problem. The sand blasting process conditions were determined by using these problematic cracks as a characteristic value. The present study, however, reconsidered the processing conditions by performing a parameter design focused on the relation between the input of processing energy and the processed output volume. Specifically, an L18 orthogonal array experiment was carried out, using the number of scans made by the processing nozzle as input and the processing depth as output. Optimization of the processing conditions by means of this parameter design resulted in a 4 db improvement. When production was carried out under the optimized conditions, dimensional variability was reduced to approximately one third of its former value, and the rate of occurrence of the quality problem of processing cracks was reduced to approximately one eighth.</p>

収録刊行物

  • 品質工学

    品質工学 25 (1), 24-31, 2017

    一般社団法人 品質工学会

詳細情報 詳細情報について

問題の指摘

ページトップへ