No.1 化学気相浸透法で調製した炭素内装塊成鉱の強度と反応性(灰・微量元素(1)、重質油・バイオマス・コプロセッシング(1))

DOI

書誌事項

タイトル別名
  • No.1 Crushing strength and reduction reactivity of a carbon-containing pellet prepared by the chemical vapor infiltration method

抄録

The crushing strength and reduction reactivity of a carbon-containing pellet prepared from a cold bonded pellet (CP) and COG tar have been examined with a tensile and compression machine and with a fixed-bed quartz reactor, respectively. The C-containing pellet is prepared by the chemical vapor infiltration (CVI) method under the conditions of tar pyrolysis temperature of 700℃ and CVI temperature of 350℃. When CP is heated up to 350℃, specific surface area (S_<BET>) and total pore volume (VEJB) increase from 20 to 60 m^2/g and from 0.06 to 0.075 cm^3/g, respectively, and the profile for pore size distribution gives a district peak around 2 nm. On the other hand, S_<BET> and V_<BJH> values of CVI sample are as low as < 1 m^2/g and < 0.01 cm^3/g, respectively, and the peak observed around 2 nm disappears completely. The crushing strength of the sample reaches 10 daN, and the value is comparable to those of typical metallurgical cokes. The evolution of CO, CO_2 or H_2O starts at 300-400℃, and the maximal rates of these gases evolved are observed around 700-800℃ during heat treatment of the sample in He. The extent of redaction after 60 min holding at 1000℃ reaches > 85%, and metallic-Fe is formed above 800℃.

収録刊行物

詳細情報 詳細情報について

  • CRID
    1390282680747506560
  • NII論文ID
    110010011887
  • DOI
    10.20550/jiesekitanronbun.52.0_2
  • ISSN
    24238309
    24238295
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ