1014 MEASUREMENT OF LIQUID FRACTION DISTRIBUTION OF HIGH SPEED WATER JET BY LASER SHRIELEN METHOD
-
- Hiroyuki Abe
- Chemical Grouting Co. Ltd
-
- Kenji Yoshida
- Department of Mechanical Engineering, Osaka University
-
- Yuichi Fukuhara
- Department of Mechanical Engineering, Osaka University
-
- Isao Kataoka
- Department of Mechanical Engineering, Osaka University
説明
In order to evaluate the performance of water jet, radial density distribution or liquid fraction distribution of jet is one of the most important parameters. However, no measurements have been carried out do for due to the very high speed (order of several hundred meters per sec) of water jet. The authors have developed newly measurement system of liquid fraction distribution of high speed water jet using Laser Schrielen method. Laser beam is expanded to parallel beam and crosses the water jet. Then the beam is collected by lens and expanded again through pin hole and recorded by digital camera. From the two-dimensional recorded image, liquid fraction distribution in radial direction of water jet is reconstructed by tomographic method. The experiments were carried out using high speed water jet of industrial use, the nozzle diameter is 1.7 mm, and pressure at outlet of nozzle is 0.1-20 MPa. Radial distributions of liquid fraction were successfully obtained at various positions form nozzle exit. Numerical simulation of water jet was also carried out using homogeneous droplet flow models. The predicted density distributions reasonably agree with experimental data.
収録刊行物
-
- Jets, wakes and separated flows : proceedings of International Conference on Jets, Wakes and Separated Flows, ICJWSF
-
Jets, wakes and separated flows : proceedings of International Conference on Jets, Wakes and Separated Flows, ICJWSF 2013.4 (0), _1014-1_-_1014-6_, 2013
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680857378304
-
- NII論文ID
- 110009962629
-
- ISSN
- 24242888
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可