内歯車のスカイビング加工用テーパカッタ設計法に関する研究

DOI Web Site 被引用文献1件

書誌事項

タイトル別名
  • Taper Cutter for Internal Gear Skiving
  • （中心距離の増加に伴い変化する共役ピニオンを用いた力ッタ）
  • (Cutter Obtained from Conjugate Pinion Changed with Increase of Center Distance)

説明

<p>The final purpose of the present study is to create design method of taper cutter for internal gear skiving. For this purpose, first of all, the reference cutter geometry on the basis of conjugate pinion was discussed. Conjugate pinions and cutting edges must be calculated according to Variation in center distance. After that, these cutting edges are aligned along with the lead of the conjugate pinion with the minimum center of distance and a taper cutter is constructed. Comparing the conjugate pinion and the taper cutter in a same coordinate system depicted in a figure, the taper cutter was confirmed to be inside of the conjugate pinion. So, this taper cutter does not interfere with the target internal gear in its cutting process. In addition the radial clearance angles of the taper cutter were smaller than those of the conjugate pinion. And chordal tooth thicknesses at some radii of taper cutter were smaller than those of the conjugate pinion. Therefore, it was confirmed that this taper cutter had some clearances on its top land and its tooth flanks between the target internal gear and itself.</p>

収録刊行物

被引用文献 (1)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ