A23 Fundamental Study for Development of Metallic Functional Material by Nano/micro Plastic Forming(M4 processes and micro-manufacturing for science)
-
- KAWANISHI Tsuyoshi
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
- YAMANAKA Akinori
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
- YOSHINO Masahiko
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
- HIBINO Ryo
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
- KIMURA Hidehiko
- Eco Topia Science Institute, Nagoya University
抄録
This paper proposes a new process to obtain functional metallic material by combination of nano/micro plastic forming and annealing. Nano/micro plastic forming tests of single crystal copper specimens were conducted by using a knife edge tool made of diamond. The formed specimens were annealed under various conditions. Nano/micro-formed specimens and annealed specimens were analyzed by SEM-EBSD. Based on the results, effects of indentation force and annealing temperature on the recrystallization behavior are discussed. The efficacy of the proposed process for microstructure control is demonstrated.
収録刊行物
-
- Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
-
Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 2009.5 (0), 301-304, 2009
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282680876814976
-
- NII論文ID
- 110008010240
-
- ISSN
- 24243086
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可