A36 Research on End Milling Process of CFRP

DOI Web Site

Bibliographic Information

Other Title
  • A36 CFRPのエンドミル加工に関する研究(OS13 環境適応型加工(1))

Abstract

This paper deals with the influence of cutting speed and feed rate on tool wear in the end milling of CFRP. As a result, in dry cutting, the tool life increases with decreasing the cutting speed, and the cutting speed of 69 m/min is suitable. The tool life obtained with the feed rate of 100 mm/min is longer than that obtained with 200 mm/min. It was found that the supply of water as a cutting fluid prolongs the tool life at a high cutting speed of 126 m/min, although the water is ineffective at the cutting speeds of 69 and 93 m/min.

Journal

Keywords

Details 詳細情報について

Report a problem

Back to top