21pm3-PM001 熱硬化性樹脂の注型によるマイクロニードルの作製

DOI Web Site

書誌事項

タイトル別名
  • 21pm3-PM001 Fabrication of a microneedle by cast molding of thermosetting resin

説明

A method for fabricating a low invasive microneedle which is three-dimensionally imitating mouthparts of mosquito was proposed. In this method, the microneedle is fabricated by casting of a thermoset epoxy resin into a micromold. Microneedles made of the thermoset epoxy resin were tried to fabricate using proposed method. As a result, the microneedles with fine-shaped tip were successfully formed when those diameters are larger than 100 μm. It was also confirmed that the fabricated microneedle can puncture into artificial skin (Young's modulus is 0.1 MPa) without buckling.

収録刊行物

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ