Slurry Chemical Corrosion and Galvanic Corrosion during Copper Chemical Mechanical Polishing.

DOI Web Site Web Site Web Site 被引用文献11件 参考文献22件
  • Kondo Seiichi
    Central Research Laboratory, Hitachi, Ltd., 1-280 Higashi-Koigakubo, Kokubunji-shi, Tokyo 185-8601, Japan
  • Sakuma Noriyuki
    Central Research Laboratory, Hitachi, Ltd., 1-280 Higashi-Koigakubo, Kokubunji-shi, Tokyo 185-8601, Japan
  • Homma Yoshio
    Central Research Laboratory, Hitachi, Ltd., 1-280 Higashi-Koigakubo, Kokubunji-shi, Tokyo 185-8601, Japan
  • Ohashi Naofumi
    Device Development Center, Hitachi, Ltd., 6-16-3 Shin-machi, Oume-shi, Tokyo 198-8512, Japan

この論文をさがす

説明

Copper (Cu) corrosion during chemical mechanical polishing (CMP) was controlled in order to improve the Cu damascene interconnect process. Slurry chemical corrosion was found to be enhanced when the slurry was diluted by deionized (DI) water during rinsing just after CMP. Since the corrosion inhibitor, benzotriazole (BTA), reduces the Cu removal rate, adding it to the rinse solution prevents chemical corrosion more effectively than adding it to the slurry. On the other hand, galvanic corrosion occurs at the interface between Cu and the barrier metal, and it can be prevented by selecting appropriate barrier metals. Because the difference between the electrochemical potentials of Cu and the barrier metal is small in the slurry, refractory metals such as Ta, TaN, and TiN were found to be appropriate barrier metals. On the other hand, W, WN, and Ti have large potential differences, so galvanic corrosion was clearly observed when Cu/W damascene interconnects were fabricated.

収録刊行物

被引用文献 (11)*注記

もっと見る

参考文献 (22)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ