書誌事項
- タイトル別名
-
- Injection Molding of Metal Powder with Use of Depolymerization Polymers (I) Injection Molding of SUS316L Powder with Use of Polybutyl-methacrylate and Polystylene.
- カイジュウゴウ ポリマー オ モチイタ キンゾク フンマツ ノ シャシュツ セ
この論文をさがす
抄録
Injection molding of metal powder with use of depolymerization polymers were discussed.<BR>The compound used by this process consisted essentially of PBMA(Polybutyl-methacrylate) and PS (Polystylene). It was clarified that the rate of degradation of this compound were faster than that of compound which contain a good deal of random degradation polymers (PP(Polypropylene) and EVA(Ethylene-vinyl-acetate)). On the compound which contain a good deal of depoiymerization polymers, the degree of distortion of the test piece on thermal debinding process increased with an increase of PBMA content of the compound, the sintered bodys include only 20ppm of carbon, and the relative density of sintered body was 96%.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 40 (5), 536-540, 1993
一般社団法人 粉体粉末冶金協会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681282980096
-
- NII論文ID
- 130000819283
-
- NII書誌ID
- AN00222724
-
- ISSN
- 18809014
- 05328799
-
- NDL書誌ID
- 3827488
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可