書誌事項
- タイトル別名
-
- Molybdenum Powder Elution Behavior to Water
- モリブデン フンマツ ノ ミズ エ ノ ヨウシュツ シケン
この論文をさがす
抄録
The press process of molybdenum is done without using an organic binder when the molybdenum is manufactured at high temperature used in powder metallurgy. The decrease in the molybdenum ingot density, which was a factor in the yield decrease of the molybdenum product, is occurred because of remaining moisture and the presence of molybdenum oxide in molybdenum metal powder. To clarify the cause of the yield decrease, the uniform distribution process of the rare earth salt by wet doping into molybdenum and the molybdenum elution to water were examined. The dopants provide a unique effect on the thermal-deformation resistance of molybdenum. In solvents of purified water and tap water, the amount of elution of molybdenum was examined as dependence on molybdenum particle sizes and the temperatures of the solvent. Moreover, elution results obtained using alkali and acid water solvents were compared. As a result, it can be suggested that a steady dope manufacturing condition can be obtained by using the metallic molybdenum or MoO2 as the raw powder, as well as by the use of purified water held at a low temperature.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 57 (7), 485-491, 2010
一般社団法人 粉体粉末冶金協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681284273280
-
- NII論文ID
- 10026872018
-
- NII書誌ID
- AN00222724
-
- COI
- 1:CAS:528:DC%2BC3cXpslOhtL4%3D
-
- ISSN
- 18809014
- 05328799
-
- NDL書誌ID
- 10782719
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可