Investigation of Fine Heterogeneous Microstructure on the Mechanical Properties of MIM Fe-Ni Alloy Steels
-
- WAN HARUN Wan Sharuzi
- Graduate School of Kyushu University
-
- OSADA Toshiko
- Dept. Mechanical Eng., Kyushu University
-
- KANG Hyungoo
- Dept. Mechanical Eng., Kyushu University
-
- TSUMORI Fujio
- Dept. Mechanical Eng., Kyushu University
-
- MIURA Hideshi
- Dept. Mechanical Eng., Kyushu University
この論文をさがす
抄録
The influence of nickel particle sizes, nickel mass%, and sintering temperatures on the microstructure and mechanical properties of injection molded Fe-Ni compacts have been studied. The mixed elemental carbonyl iron and water-atomized nickel powders were utilized in this study. Tempered compact added 6 mass% fine nickel powder which was sintered at 1250°C for 1 hour showed superhigh strength of 2040 MPa with elongation of 8.1 %, the best properties among reported data in MIM low alloy steel compacts. These excellent mechanical properties by fine heterogeneous microstructure of the compact are explained in terms of the complicated networks of nickel content variation throughout the steel matrix.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 59 (12), 677-684, 2012
一般社団法人 粉体粉末冶金協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681287039232
-
- NII論文ID
- 10031148157
-
- NII書誌ID
- AN00222724
-
- COI
- 1:CAS:528:DC%2BC3sXhsVGgt7g%3D
-
- ISSN
- 18809014
- 05328799
-
- NDL書誌ID
- 024211057
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可