書誌事項
- タイトル別名
-
- Evaluation and Analysis of Distortion during MIM Process of Titanium Alloy Materials -2nd Report-
- MIMプロセスにおけるチタン合金部材の変形挙動の評価ならびに解析(第2報)
- MIM プロセス ニ オケル チタン ゴウキン ブザイ ノ ヘンケイ キョドウ ノ ヒョウカ ナラビニ カイセキ(ダイ2ホウ)
この論文をさがす
抄録
The use of titanium alloy component in automotive applications can lead to weight reduction and functional development such as life time, corrosion resistance as well. Metal Injection Molding (MIM) offers an efficient way to fabricate more complex shaped components of titanium alloys. However, MIM process is mostly applied for small parts. Fabrication of larger parts by MIM process is limited because much binder contain in MIM green parts makes it difficult to remove the binders without distortion or defects. The purpose of this study is to investigate the effects of processing parameters on the distortion of larger size specimen than usual MIM components. Specimens with different diameter and thickness were injection molded and especially the effect of thermal debinding conditions on the distortion was investigated in detail. Thick specimens needed slow thermal debinding heating rate to minimize the distortion. Moreover, distortion in MIM process was considered and it was clarified that the distortion after solvent debinding was bigger than other process, thus, the debinding condition was most important to control the distortion.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 59 (5), 272-277, 2012
一般社団法人 粉体粉末冶金協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681287354112
-
- NII論文ID
- 10030765135
-
- NII書誌ID
- AN00222724
-
- COI
- 1:CAS:528:DC%2BC38Xos1ars74%3D
-
- ISSN
- 18809014
- 05328799
-
- NDL書誌ID
- 023804923
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可