書誌事項
- タイトル別名
-
- Method for Cutting Straight Bevel Gears Using Quasi-Complementary Crown Gears.
- ジュン カソウ カンムリハグルマ オ モチイタ スグバ カサハグルマ ノ ハギ
この論文をさがす
抄録
In the manufacture of straight bevel gears, there is usually a need for some "trial-and-error" process by which a good tooth bearing is obtained. In this paper, a method for cutting straight bevel gears in which a trial-and-error process is not necessary is proposed. The method can be applied without the necessity of cutter modification or generator alteration. Each gear and pinion is generated by a newly introduced "quasi-complementary crown gear" instead of a conventional complementary crown gear. The quasi-complementary crown gear is a bevel gear whose pitch cone angle is 90° minus the root angle of the workpiece and whose tooth surface is a plane. The pitch cones of the quasi-complementary crown gear and workpiece roll with each other. Therefore, the ratio of roll between the crown gear and workpiece is expressed as a function of the root angle. The quasi- complementary crown gear produces a profile modification of the generated gear tooth. Gears made on an experimental basis showed a good tooth bearing as expected.
収録刊行物
-
- 日本機械学会論文集C編
-
日本機械学会論文集C編 63 (606), 579-584, 1997
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681303593344
-
- NII論文ID
- 110002384970
-
- NII書誌ID
- AN00187463
-
- ISSN
- 18848354
- 03875024
-
- HANDLE
- 10191/5826
-
- NDL書誌ID
- 4149958
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可