ガス発生剤による超塑性５０８３アルミニウム合金の新しいバルジ成形法

DOI Web Site 被引用文献1件 参考文献10件

書誌事項

タイトル別名
  • New bulge forming with gas generant for superplastic 5083 aluminum alloy
  • ガス ハッセイザイ ニ ヨル チョウソセイ 5083 アルミニウム ゴウキン ノ アタラシイ バルジ セイケイホウ

この論文をさがす

説明

Gas blow forming originally developed to thermoplastics has been revised and applied to superplastic alloy sheets. It involves, however, low production rate, high cost for forming tools and poor working environment due to heating. Instead of using inert gas or air blowing, dilatational work of inert gases during heating was inspired by authors as a kind of pressure source. Several gas generants being used in forming foamed plastics or metals and air bag in car seem to be available for the purpose. A few of gas generants in form of powder were tentatively selected and supplied for experiments here. Conventional gas blow forming and proposed method with using these gas generants were compared with regard to formability and cavitation. Experimental results on superplastic aluminum sheets obviously demonstrate a feasibility of practical use of it in engineering application.

収録刊行物

  • 軽金属

    軽金属 54 (8), 323-327, 2004

    一般社団法人 軽金属学会

被引用文献 (1)*注記

もっと見る

参考文献 (10)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ