書誌事項
- タイトル別名
-
- Geometrical Study on Machining Mechanism at Center of Ball-Nosed End Mill.
- ボール エンド ミル カコウ ニ オケル コウグ カイテン チュウシン キンボウ ノ セッサク キコウ ニ カンスル キカテキ コウサツ
この論文をさがす
抄録
This paper presents a geometric analysis of an undeformed chip thickness at the top of tool in ball-nosed end milling. It has been firstly pointed out "backward cutting" near the center of tool that is irregular interference between the flank and the workpiece. So "backward cutting" occurs a non contact part on the cutting edge. Secondly a condition of "backward cutting" has been clarified. An area of "backward cutting" in a ball-nosed end mill is shaped circle that exists beside the center of tool axis. Thirdly a method of avoidance from "backward cutting" has been brought up. Then its influence for surface roughness is verified by a few experiments.
収録刊行物
-
- 日本機械学会論文集Ｃ編
-
日本機械学会論文集Ｃ編 68 (672), 2457-2463, 2002
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681332977792
-
- NII論文ID
- 130004234428
- 110002378640
- 10011466050
-
- NII書誌ID
- AN00187463
-
- COI
- 1:CAS:528:DC%2BD38XotF2ktLY%3D
-
- ISSN
- 18848354
- 03875024
- http://id.crossref.org/issn/00290270
-
- HANDLE
- 10228/321
-
- NDL書誌ID
- 6275079
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可