書誌事項
- タイトル別名
-
- A Study on Gear Honing Using Grinding Wheel Shaped in Internal Gear.
抄録
The gear honing is well used recently as a gear finishing method. Under such circumstance, an extension of the grinding wheel life and a decrease of the processing cost are the urgent demand. In this paper, a new honing method of extending the grinding wheel life is proposed to respond to this demand, furthermore the calculation method of both the sliding velocity and sliding angle which may affect the honing efficiency is described because of the proposed method inducing the change of the sliding-velocity and -angle according to the amount of wheel dressing. The proposed method is a method of changing the setting angle between work shaft and wheel shaft corresponding the setting distance between the both axes.
収録刊行物
-
- 日本機械学会論文集C編
-
日本機械学会論文集C編 69 (679), 721-726, 2003
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681334995840
-
- NII論文ID
- 130004234701
-
- ISSN
- 18848354
- 03875024
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可