書誌事項
- タイトル別名
-
- A Countermeasure Against a Rifling Mark Generating Phenomenon on BTA Deep Hole Drilling Process(Mechanical Systems)
- BTA深穴加工におけるライフリングマーク発生現象の防止対策
- BTAシンケツ カコウ ニ オケル ライフリングマーク ハッセイ ゲンショウ ノ ボウシ タイサク
- A countermeasure against a rifling mark generating phenomenon on BTA deep hole drilling process
この論文をさがす
抄録
BTA deep hole drilling is used for producing holes of high aspect ratio. In this process, a chatter vibration sometimes occurs and a rifling mark is formed on the surface of the hole. The generating mechanism of the rifling mark in BTA deep hole drilling process has been studied as a self-excited vibration caused by time delay. In this paper, a BTA machining head which has two guide pads is treated, and countermeasures against the generation of rifling mark phenomenon are considered. The influence of the locations of the guide pads is analyzed. Also, the preventing method by an additional guide pad is proposed, and the effect of the preventing method is investigated. Furthermore, the optimal location of the guide pads is studied by quasi-static analysis. According to the numerical result, it was confirmed that the perfect prevention of the generation of rifling mark phenomenon was possible by using an additional guide pad and locating the guide pads appropriately.
収録刊行物
-
- 日本機械学会論文集Ｃ編
-
日本機械学会論文集Ｃ編 76 (767), 1684-1691, 2010
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681362733312
-
- NII論文ID
- 110007682159
-
- NII書誌ID
- AN00187463
-
- ISSN
- 18848354
- 03875024
-
- NDL書誌ID
- 10784271
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可