End Milling of Carbon Steel Using Electrolyzed Reduced Water

DOI Web Site Web Site 11 Citations

Bibliographic Information

Other Title
  • 電解還元水を用いた炭素鋼のエンドミル加工
  • デンカイ カンゲンスイ オ モチイタ タンソ コウ ノ エンドミル カコウ

Search this article

Abstract

This paper describes development of end milling of carbon steel by electrolyzed reduced water of dilute sodium chloride solution, instead of conventional cutting with cutting fluid which is not environmentally consciousness. First, experimental equipments were built with a machining center, cutting fluid supply system made from the bath pump, temperature sensor and temperature recorder etc., and end milling processing of carbon steel was performed using electrolyzed reduced water of dilute sodium chloride solution and conventional cutting fluid respectively. Next, measured surface roughness, evaluated surface deterioration layer, temperature change of work piece and wear state of end milling. As the results of all evaluations above-mentioned, there is no difference between the end milling process using electrolyzed reduced water and that of conventional using cutting fluid. It is supposed electrolyzed reduced water instead of cutting fluid is environmentally consciousness process.

Journal

Citations (11)*help

See more

Keywords

Details 詳細情報について

Report a problem

Back to top