書誌事項
- タイトル別名
-
- Mixing of Molten Steel in a Ladle with RH Reactor by the Water Model Experiment
- ミズ モデル ジッケン ニヨル RH ダツ ガス ソウチ ノ ナベナイ コンゴ
この論文をさがす
抄録
In order to recognize the mixing of molten steel in a ladle with RH reactor, the water model experiment was carried out.<br>The results are as follows:<br>(1) The circulation rate extremely depends on the methods of gas injection. Better result can be obtained when an up-leg has multi-nozzles and gas bubble reaches near the center of the up-leg.<br>(2) The flow coming out from a down-leg reaches the bottom of the ladle and goes up as if it creeps along the bottom. The short circuit flow between the down-leg and the up-leg does not occur.<br>(3) It is better to make the down-leg turn towards the center of the bottom of the ladle in order to reduce flow stagnant zone.<br>(4) In the case of multi-leg RH and in the case that the area of the down-leg is different from the up-leg, the circulation rate is higher when area of the down-leg is bigger than the up-leg. On the other hand, the mixing time is shorter in the opposite case.<br>This can be explained by that the mixing time is the function of energy of flow from the down-leg rather than the function of the circulation rate.
収録刊行物
-
- 電気製鋼
-
電気製鋼 50 (2), 128-137, 1979
大同特殊鋼株式会社
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681397207296
-
- NII論文ID
- 130000743053
-
- NII書誌ID
- AN00152276
-
- ISSN
- 18834558
- 00118389
-
- NDL書誌ID
- 2049707
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可