-
- HAYASHI Chihiro
- Iron & Steel Research Center, Technical Research Laboratories, Sumitomo Metal Industries, Ltd.
-
- UTAKOJI Masaru
- Wakayama Steel Works, Sumitomo Metal Industries, Ltd.
-
- YAMADA Tateo
- Iron & Steel Research Center, Technical Research Laboratories, Sumitomo Metal Industries, Ltd.
-
- WATANABE Masaki
- Kainan Steel Tube Works, Sumitomo Metal Industries, Ltd.
-
- NAKANISHI Renpei
- Kainan Steel Tube Works, Sumitomo Metal Industries, Ltd.
説明
Mandrel mill hydraulic screwdown control was successfully installed at the Kainan Steel Tube Works of Sumitomo Metal Industries, Ltd. in July, 1985. The purpose o f the control is to preform tube ends in a thin tapered form. By preforming the tube ends, it is possible to cancel the end thickening in the reducer and reduce the length of crop losses.<br>The analysis of variations in inter-stand tensions when the above end thinning control is carried out and the methods of roll speed control to prevent these variations are first discussed. Secondly, the causes of the wall eccentricity in the end thinning control and its countermeasures are described. Thirdly, the computer control system installed at the Kainan Steel Tube Works is presented. Lastly, the effects of the end thinning control are described.
収録刊行物
-
- Transactions of the Iron and Steel Institute of Japan
-
Transactions of the Iron and Steel Institute of Japan 28 (6), 440-447, 1988
一般社団法人 日本鉄鋼協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681427977472
-
- NII論文ID
- 130003457300
-
- ISSN
- 18811183
- 00211583
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可