-
- Tanaka Eihachiro
- The Research Institute for Iron, Steel and Other Metals, Tôhoku University
-
- Fukuda Takeshi
- The Research Institute for Iron, Steel and Other Metals, Tôhoku University
-
- Tsunokawa Kiyoo
- Hitachi Wire & Cable Ltd.
Bibliographic Information
- Other Title
-
- 冷間圧延ストリップのカーリング
- レイカン アツエン ストリップ ノ カーリング
Search this article
Abstract
The effect of cold rolling conditions upon residual stress of strip and diameter of curled coils have been investigated. If tension is relieved after rolling, cold-rolled thin strips will curl to the upper work-roll side, when the upper work-roll has a slight offset to the rolling direction from the line of centers of the lower work-roll and two back-up rolls, when the upper work roll is a little smaller in diameter than the lower-roll, and when the passline of the strips leans to the upper roll side at the exit. These results, obtained from calculations based on the residual stress distribution reported by Baker,Ricksecker and Baldwin, have been proved by the rolling experiment using a Sendzimir 20-high mill.
Journal
-
- Journal of the Japan Institute of Metals and Materials
-
Journal of the Japan Institute of Metals and Materials 26 (2), 112-116, 1962
The Japan Institute of Metals and Materials
- Tweet
Details 詳細情報について
-
- CRID
- 1390282681457756800
-
- NII Article ID
- 40018258064
- 130007332426
-
- NII Book ID
- AN00187860
-
- ISSN
- 18806880
- 24337501
- 00214876
-
- NDL BIB ID
- 9153504
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed