AISI 321型18-12 Tiステンレス鋼鍛造材のクリープ破断性質について

DOI Web Site Web Site

書誌事項

タイトル別名
  • On Creep Rupture Properties of AISI 321 Stainless Steel Forgings (Creep Rupture Properties of 18-8 Ti Stainless Steel, 3rd Report)
  • AISI321ガタ 18-12Ti ステンレス コウ タンゾウザイ ノ クリープハダンセイシツ ニ ツイテ

この論文をさがす

抄録

The effect of cold-working, grain size and heat-treatment on the creep rupture properties of AISI 321 stainless steel has been investigated. 650°C creep rupture tests up to about 3,000 hrs have been carried out with the forged materials under 9 different conditions. The results were as follows: (1) The creep rupture strength of 40% cold-worked material is large at the beginning, but it decreases considerably with time and became smaller than that of annealed material. With 20% cold-worked material, a large creep rupture strength is maintained for a long time, but the elongation at rupture is small. (2) The grain size has only a slight bearing upon the creep rupture strength. (3) The creep rupture strength is affected greatly by the heat-treatment after working. The creep rupture strength is small when the material is subjected to low-temperature heat-treatment, and large when subjected to high-temperature heat-treatment. The rupture elongation is decreased by higher-temperature solution-treatment. But, even though the material has been solution-treated at 1,200°C, it has the rather high elongation of 15%. (4) If the solution-treatment temperature before cold working is high, the decrease in the creep rupture strength due to cold-working is much retarded.

収録刊行物

  • 日本金属学会誌

    日本金属学会誌 26 (10), 661-664, 1962

    公益社団法人 日本金属学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ