-
- Gokyû Isao
- Faculty of Engineering, University of Tokyo
-
- Okubo Tadatsune
- Faculty of Engineering, University of Tokyo
-
- Horiuchi Ryô
- Faculty of Engineering, University of Tokyo
-
- Igarashi Kiyoyuki
- Faculty of Engineering, University of Tokyo
Bibliographic Information
- Other Title
-
- ローラーダイスの力学的特性
- ローラーダイス ノ リキガクテキ トクセイ
Search this article
Abstract
In order to obtain guiding principles for development of the roller dies for practical use, researches for drawing of rectangular bar through flat rollers were carried out. The drawing force, the roller separating force and the spread of square wire were measured under various drawing conditions, namely, various roller diameters, wire sizes, reduction in one pass and backward tensions. Calculations of the drawing force, the roller separating force and the roller pressure during drawing of wide strip through flat rollers were done by using the elementary two-dimentional theory of plasticity. Based on above results, guiding principles for development of the practical roller dies are mentioned.
Journal
-
- Journal of the Japan Institute of Metals and Materials
-
Journal of the Japan Institute of Metals and Materials 27 (12), 611-618, 1963
The Japan Institute of Metals and Materials
- Tweet
Details 詳細情報について
-
- CRID
- 1390282681458583808
-
- NII Article ID
- 40018258209
- 130007333541
-
- NII Book ID
- AN00187860
-
- ISSN
- 18806880
- 24337501
- 00214876
-
- NDL BIB ID
- 9153649
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed