Ti–6Al–4Vレーザー積層材の組織と機械的特性

DOI Web Site Web Site 被引用文献4件 参考文献12件
  • 櫻井 勇也
    首都大学東京大学院理工学研究科機械工学専攻
  • 筧 幸次
    首都大学東京大学院理工学研究科機械工学専攻

書誌事項

タイトル別名
  • Microstructure and Mechanical Properties of Ti–6Al–4V parts build by Selective Laser Melting
  • Ti-6Al-4Vレーザー セキソウザイ ノ ソシキ ト キカイテキ トクセイ

この論文をさがす

説明

<p>Additive manufacturing(AM)is the relatively recent process suitable for small - volume production in great varieties. The microstructure of Ti–6Al–4V melted by selective laser melting(SLM)using laser as a heat source and the relationship between the microstructure and mechanical properties were investigated comparing with electron beam melting(EBM)and conventional mill-annealed specimens. The effects of built direction and heat treatment on the tensile and creep properties of Ti–6Al–4V, fabricated by SLM, were also examined. The compositional image in BSE mode and electron backscatter diffraction(EBSD)analysis revealed SLM and EBM specimens were found to consist of acicular α grain transformed from α′ martensite and very fine β distributed in α/α grain boundary. Prior β boundaries were also observed. α+β equiaxed grains were observed in the conventional mill-annealed specimen. Conventional standard heat treatment(954°C/2 h(WQ)+538°C/4 h(AC))improved tensile and creep strengths in the mill-annealed specimen, however it did not improve the strengths in the SLM specimens so much. The tensile and creep strengths were comparable between the horizontal-direction and the vertical-direction specimens, i.e., SLM specimen showed isotropic mechanical properties.</p>

収録刊行物

  • 日本金属学会誌

    日本金属学会誌 81 (3), 120-126, 2017

    公益社団法人 日本金属学会

被引用文献 (4)*注記

もっと見る

参考文献 (12)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ