Cu-Al-Ni3元系焼結合金の内部摩擦

DOI Web Site Web Site

書誌事項

タイトル別名
  • On the Internal Friction of Sintered Cu-Al-Ni Ternary Alloys
  • Cu Al Ni 3ゲンケイ ショウケツ ゴウキン ノ ナイブ マサツ

この論文をさがす

抄録

Effects of chemical compositions, porosities and cooling rates on the maximum internal friction were examined for sintered Cu-Al-Ni ternary alloys which were heat-treated after sintering, and the results obtained are as follows.<BR>(1) The maximum value of Q−1max in sintered Cu-Al-8 wt%Ni alloys with different Al contents was obtained at 14 wt%Al.<BR>(2) The value of Q−1max in sintered Cu-14 wt%Al-Ni alloys increased with increasing Ni content and showed a maximum value at 8 wt%Ni, where the value of Q−1max is propotional to the amount of γ′ martensite.<BR>(3) The value of Q−1max in sintered Cu-14 wt%Al-8 wt%Ni alloys increased slightly with increasing porosity. On the other hand, the Q−1max was kept constant at the rates higher than 300°C/min after showing a linear increase with increasing cooling rate up to about 300°C/min. These results indicated that Q−1max depended on the amount of γ′ martensite rather than that of porosities, where γ′ single phase martensite could be obtained from the sintered Cu-14 wt%Al-8 wt%Ni cooled at the rates higher than 300°C/min.

収録刊行物

  • 日本金属学会誌

    日本金属学会誌 43 (10), 966-971, 1979

    公益社団法人 日本金属学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ