-
- Otsuka Takayuki
- R&D Center, Nippon Steel & Sumitomo Metal Corporation
-
- Sakamoto Masashi
- R&D Center, Nippon Steel & Sumitomo Metal Corporation
-
- Takamachi Yasuyuki
- R&D Center, Nippon Steel & Sumitomo Metal Corporation
-
- Higashida Yasuhiro
- Nippon Steel & Sumikin Research Institute Corporation
-
- Segawa Yuji
- Oita Works, Nippon Steel & Sumitomo Metal Corporation
-
- Takeshima Shohta
- Oita Works, Nippon Steel & Sumitomo Metal Corporation
説明
<p>A new online rolling model of the draft schedule setup for a plate mill has been developed. This model comprises plate temperature, rolling force function and flow stress calculations and their coupling for the roll separating force estimation. The roll separating force calculation is also used when the work roll gap control is made realising a precise plate thickness control for each rolling pass, which is often referred to as an adaptive control. The temperature model and roll separating force model, as well as its inverse calculation (calculate entry thickness from exit thickness and given roll separating force), are involved in the draft schedule setup calculations. Plate rolling is carried out according to the setup calculation results and thus the product plate quality is largely attributable to the setup calculation preciseness. In this model, a one dimensional finite element model is employed to the temperature calculation that enables a precise temperature control which is necessary for the Controlled Rolling (CR) technology. Another development includes the rolling force function model; a new mathematical model which takes the peening effect into account, derived from the three-dimensional rigid-plastic finite element calculations. Finally, a flow stress model is developed taking into account the metallurgical nature such as work hardening, recrystallization and recovery. The coupling of these models allows to a physical based precise model without unnecessary artificial fitting parameters.</p><p>In addition, for eliminating the convergence loop, an attempt has been made introducing a multi thread computing using General Purpose computing on Graphic Processing Unit (GPGPU). Thanks to this parallel computing technique, the computational time was remarkably reduced. The model was installed in a process computer and some trial rolling tests were conducted.</p>
収録刊行物
-
- ISIJ International
-
ISIJ International 57 (11), 2042-2048, 2017
一般社団法人 日本鉄鋼協会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681464009088
-
- NII論文ID
- 130006206558
-
- ISSN
- 13475460
- 09151559
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可