Influence of Raw Material Type on Heat Transfer and Structure of Mould Slag
-
- Wen Guang Hua
- College of Materials Science and Engineering, Chongqing University
-
- Zhu Xin Bai
- College of Materials Science and Engineering, Chongqing University
-
- Tang Ping
- College of Materials Science and Engineering, Chongqing University
-
- Yang Bo
- College of Materials Science and Engineering, Chongqing University
-
- Yu Xiong
- College of Materials Science and Engineering, Chongqing University
この論文をさがす
説明
The effect of the raw materials and mixing ratio on the heat transfer and structure of mould slag was studied in the present paper. Three groups of mould slag with identical chemical composition were designed by various raw materials and mixing ratio. The result indicates that the raw material has minor effect on viscosity, melting point and crystalline phase of the mould slag; whereas, it affects the formation and size of crystal. The wollastonite in slag has higher crystallization capacity; therefore, it promotes the formation of thicker solid slag film with higher porosities and consequently prevents the strong heat flux through the slag film. Compared with wollastonite, prefused material in the slag has capability to restrain the crystallization process; hence, the thinner solid slag film with uniform size and finer grain is formed. The experiment proves that prefused mould powder has good performance on heat transfer.
収録刊行物
-
- ISIJ International
-
ISIJ International 51 (7), 1028-1032, 2011
一般社団法人 日本鉄鋼協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681465554432
-
- NII論文ID
- 10030381872
-
- NII書誌ID
- AA10680712
-
- COI
- 1:CAS:528:DC%2BC3MXpsVKltr0%3D
-
- ISSN
- 13475460
- 09151559
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可