Permeability Enhancement by Microfracturing in Granite under Supercritical Water Conditions.
-
- TAKAHASHI Toru
- Fracture Research institute, Tohoku University
-
- TANIFUJI Koji
- Center for Integrated research in Science and Engineering
-
- STAFFORD Catherine
- Fracture Research institute, Tohoku University
-
- HASHIDA Toshiyuki
- Fracture Research institute, Tohoku University
この論文をさがす
説明
This paper discusses the generation of micro-fractures in a granite under super critical water environment. In order to create an artificial pathway of water in geothermal reservoir with limited permeability, hydraulic stimulation technology is commonly employed. In this study, simulated hydraulic stimulation tests were performed using thick-walled cylindrical specimens of 45mm outer diameter, under temperatures up to 600°C and confining pressures up to 100MPa. The experimental results of simulated hydraulic stimulations showed that no macroscopic fracturing took place and predominant fluid flow occurred at high temperature regime. The permeability of the granite was also measured using the same cylindrical specimen configuration as used in the simulated hydraulic stimulation tests. The permeability test results showed that the permeability of the granite was enhanced drastically when the temperature exceeded the critical point of water, whilst no significant increase in the permeability was observed under the subcritical water condition. Optical microscopy of the micro-structural change revealed that the enhanced permeability was due to the formation of micro-fractures under the supercritical water environment. This laboratory-scale test result suggests that it may be possible to generate a micro-fracture network by injecting water into a high temperature rock mass whose conditions exceed the critical point of water and to extract the heat energy through the generated fracture network from the supercritical rock mass.
収録刊行物
-
- JSME International Journal Series A Solid Mechanics and Material Engineering
-
JSME International Journal Series A Solid Mechanics and Material Engineering 46 (1), 24-29, 2003
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681469045760
-
- NII論文ID
- 10016190955
- 30002105422
-
- NII書誌ID
- AA11179396
-
- ISSN
- 13475363
- 13447912
-
- NDL書誌ID
- 6407084
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可