Effects of Crystal Orientation on the Cutting Mechanism of the Aluminum Single Crystal : 2nd Report : On the (111) plane and the (112) end Cutting

DOI Web Site

この論文をさがす

説明

This paper describes the effects of the crystal orientation upon the cutting phenomenon. The experiment were performed by orthogonal cutting of aluminum single crystals having the (111) plane and the (112) end plane. The results show that the effects of the orientation appear clearly in the cutting phenomenon. That is, the specific cutting force Ks, the shear angle and the amount of the side flow periodically fluctuate corresponding to a change of the cutting direction. It is revealed that the cutting mechanism of polycrystalline cold rolled materials is in good conformity with one of a single crystal having (112) end plane. The mechanism in the formation of the finished surface can reasonably be explained from the slip system of the crystal.

収録刊行物

  • Bulletin of JSME

    Bulletin of JSME 26 (215), 890-896, 1983

    一般社団法人 日本機械学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ