伸線条件,および多パス伸線が細線伸線材の<br>表層部付加的せん断ひずみ層に与える影響

書誌事項

タイトル別名
  • Effect of Drawing Condition and Multipass Drawing on Additional Shear Strain Layer of Finely Drawn Wire
  • シンセン ジョウケン オヨビ タパス シンセン ガ サイセン シンセンザイ ノ ヒョウソウブ フカテキ センダン ヒズミソウ ニ アタエル エイキョウ ヒキヌキザイ ニ オケル ヒョウソウブ フカテキ センダン ヒズミソウ ノ ケンキュウ ダイ3ポウ
  • — Additional Shear Strain Layer at Surface of Drawn Wire III —
  • — 引抜き材における表層部付加的せん断ひずみ層の研究 第3報 —

この論文をさがす

抄録

Fine wires (with a diameter less than 0.4 mm) have been extensively used for precision machines and other devices. It is well known that finely drawn wires have a much higher tensile strength than thick drawn wires. One of the main factors for this characteristic has been determined to be an “additional shear strain layer”. The main purpose of this research is to clarify the relationship between the additional shear strain layer and the tensile strength of fine wire. In this paper, firstly the effects of the friction between the die and the wire and the die semiangle on the additional shear strain layer were investigated. It was ascertained that friction work was most effective for increasing the tensile strength of the additional shear strain layer and increasing in the tensile strength of the fine wire. Secondly, the additional shear strain layer generated in the multipass drawing was investigated. In the case of low-carbon steel, the increase in tensile strength of the additional shear strain layer was limited. On the other hand, the tensile strength of the additional shear strain continued to increase in high-carbon steel.

収録刊行物

  • 塑性と加工

    塑性と加工 49 (568), 414-418, 2008

    一般社団法人 日本塑性加工学会

被引用文献 (1)*注記

もっと見る

参考文献 (6)*注記

もっと見る

関連プロジェクト

もっと見る

詳細情報

問題の指摘

ページトップへ