フランジアップ成形性に及ぼす打抜き端面品質の影響

DOI Web Site Web Site 被引用文献1件 参考文献1件

書誌事項

タイトル別名
  • Effects of Sheared Sheet-Edge Quality on Flange-Up Formability
  • フランジアップ セイケイセイ ニ オヨボス ウチヌキ タンメン ヒンシツ ノ エイキョウ

この論文をさがす

説明

<p>In stretch flange forming, the sheet-edge quality is important since it affects the appearance of fractures at the edge. In this study, the effect of the edge trimming conditions of the blank sheet on both the sheet-edge quality and flange-up formability is investigated. It is found that in the case of edge trimming of a sheet with high tensile strength and poor ultimate ductility, a large burr generates at the edge, which easily causes fractures, when the shearing clearance between the upper and lower dies is large. This tendency in trimming for flange-up forming is not observed in hole piercing for hole expansion. It is clarified that the burr is caused by excessive bending behavior under large shearing clearance conditions, and that the forming limit in flange-up forming is independent of the clearance unless a large burr generates. Then, a new shearing die structure, which suppresses excessive bending, is developed in order to avoid the creation of large burrs, and consequently, high formability is attained.</p>

収録刊行物

  • 塑性と加工

    塑性と加工 57 (670), 1062-1069, 2016

    一般社団法人 日本塑性加工学会

被引用文献 (1)*注記

もっと見る

参考文献 (1)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ