-
- 古閑 伸裕
- 日本工業大学工学部
-
- 久保 雅亮
- 日本工業大学大学院生
-
- クンラチャート ジュンラペン
- 日本工業大学大学院生
書誌事項
- タイトル別名
-
- Burr-Free Shearing Using NC Servo Press Machine
- NC サーボ プレス オ リヨウシタ カエリナシ センダン
この論文をさがす
抄録
Recently, high-torque AC servomotors have been developed, and NC servo press machines equipped with these servomotors have started to become commercially available in Japan. The NC servo press machine has a programmable function to fully control the position and velocity of the slide on the machine. In this study, we experimentally examined the possibility of the burr-free shearing of an A5052 aluminum alloy sheet using such a press machine. As a result, it was clarified that burr-free shearing, which requires three processes using a conventional machining method, such as counter blanking, can be accomplished in one process using a common single-station die. The experiments also revealed that, when a punch or die, the edge of which is rounded with a radius range of 0.2-0.3 mm, is used, the range of conditions under which a sheared surface without burr generation can be obtained is wider than that for the case in which a sharp-edged tool is used.
収録刊行物
-
- 塑性と加工
-
塑性と加工 48 (558), 645-649, 2007
一般社団法人 日本塑性加工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681476518016
-
- NII論文ID
- 10018927131
-
- NII書誌ID
- AN00135062
-
- ISSN
- 18820166
- 00381586
- http://id.crossref.org/issn/00381586
-
- NDL書誌ID
- 8899964
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可