鋳鉄用原材料としてのスチール缶スクラップのリサイクル

書誌事項

タイトル別名
  • Recycling of Steel Can Scraps as Raw Materials for Flake Graphite Cast Iron
  • チュウテツヨウ ゲンザイリョウ ト シテ ノ スチールカン スクラップ ノ リサイクル

この論文をさがす

抄録

  Flake graphite cast iron using steel can scraps (SCS) as raw materials was melted in a high frequency induction furnace and cast into several kinds of molds to examine chilling tendency, tensile strength, Brinell hardness, microstructure and chemical composition. EPMA analysis and X-ray microdiffraction were carried out to determine the distribution of Al.<br>  The Al, Ti, Cr, Sn, Zn, and Mg contents increased while the P and S contents decreased with increasing amount of SCS compounded flake graphite cast iron. About 6.46 % of the Al content remained in the specimen when the SCS compounding rate was 100 %.<br>  The chill depth decreased with increasing amount of SCS compounded and increased when more than 40 % was compounded. The tensile strength increased with the amount of SCS compounded and markedly decreased when more than 20 % was compounded. Brinell hardness increased slightly with increasing amount of SCS compounded and markedly increased when more than 40 % was compounded. The graphite structure changed from type A graphite to dendritic in the specimen with more than 40 % of SCS compounded.<br>  By EPMA analysis, the Al-rich phase with high contents of Al and C was observed in granular type pearlite which formed in the specimen with more than 40 % of SCS compounded. X-ray diffraction patterns corresponding to Al-Fe-C ternary compounds (AlFe3C0.5) were obtained in this phase. The chilling tendency and mechanical properties of the specimen with less than 20 % of SCS compounded was similar to that without SCS.

収録刊行物

  • 鋳造工学

    鋳造工学 73 (6), 367-372, 2001

    公益社団法人 日本鋳造工学会

参考文献 (8)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ