小角X線散乱を用いた配合物中での充てん剤凝集構造の解析-溶液重合SBR末端に導入した官能基の効果

  • 湯淺 毅
    JSR Corporation, Performance Polymer Research Laboratories, Polymer Materials Laboratory
  • 冨永 哲雄
    JSR Corporation, Material Characterization and Analysis Laboratory
  • 曽根 卓男
    JSR Corporation, Performance Polymer Research Laboratories, Polymer Materials Laboratory

書誌事項

タイトル別名
  • Analysis of Filler Aggregation in Compounds Using Small-angle X-ray Scattering: Effect of Functional Group Introduced into Polymer-ends of Solution-polymerized SBR
  • ショウカク Xセン サンラン オ モチイタ ハイゴウブツ チュウ デ ノ ジュウテンザイ ギョウシュウ コウゾウ ノ カイセキ : ヨウエキ ジュウゴウ SBR マッタン ニ ドウニュウ シタ カンノウキ ノ コウカ

この論文をさがす

説明

Some modified styrene butadiene rubbers with functional groups at polymer chain ends have been prepared by solution polymerization system (S-SBRs). They showed reduction in the hysteresis loss of rubber compounds with silica or carbon black as reinforcing filler. Especially, the modified S-SBR with both primary amino group and alkoxysilyl group exhibited significantly lower hysteresis loss properties in both silica and carbon black compounds. In order to observe the dispersibility of silica in vulcanizates with this modified S-SBR directly, the measurements of transmission electron microscopy (TEM) and small angle X-ray scattering (SAXS) were carried out. The excellent dispersion state of silica in the vulcanizates with this modified SBR was observed. This modified SBR was also effective for improvement of dispersibility of carbon black in compound from the results of SAXS experiments. These results coincided with those obtained by dynamic viscoelastic measurement.

収録刊行物

  • 日本ゴム協会誌

    日本ゴム協会誌 86 (8), 249-255, 2013

    一般社団法人 日本ゴム協会

被引用文献 (8)*注記

もっと見る

参考文献 (19)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ