書誌事項
- タイトル別名
-
- Accuracy Validation of Measurement of Transient Thermal Stress at Steel Welds by Synchrotron X-ray Diffraction Techniques
- ホウシャコウ Xセン カイセツ ニ ヨル コウ ヨウセツブ ノ カトテキ ネツ オウリョク ソクテイ ノ セイド ケンショウ
この論文をさがす
抄録
<p>An advanced welding thermal elastic-plastic analysis, which has recently been developed by authors to improve both accuracy and reliability of welding simulation techniques, was applied to validate the measurement of transient thermal stress at steel welds by synchrotron X-ray diffraction techniques. The calculated weld penetration, temperature profiles, the transient thermal stress and distribution of residual stress at welds were compared with those measured. The results showed that there were, on the whole, comparatively good agreement between the calculations and experimental values. However, an obvious discrepancy between the calculations and experimental values can be seen in the variation behavior of stress during cooling process after welding only at weld metal (WM) and heat-affected zone (HAZ). It was thought to be due to phase transformation induced by welding. This discrepancy provides one of prospects for the future that X-ray elastic constants vary according to microstructure evolution is essential to accurately estimate the transient thermal stress and residual stress at steel welds with phase transformation. It is then expected that dependence of X-ray elastic constants on the microstructure with phase transformation is clarified more clearly. </p>
収録刊行物
-
- 材料
-
材料 68 (4), 325-331, 2019-04-15
公益社団法人 日本材料学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282763109369856
-
- NII論文ID
- 130007635149
-
- NII書誌ID
- AN00096175
-
- ISSN
- 18807488
- 05145163
-
- NDL書誌ID
- 029665988
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可