ディープホールドリリング法による極厚板多層溶接継手における内部残留応力計測の精度検証

書誌事項

タイトル別名
  • Accuracy Validation of Measurement of Through-Thickness Residual Stress in Multi-Pass Welded Joints of Very Thick Plate by Deep Hole Drilling Techniques
  • ディープホールドリリングホウ ニ ヨル ゴクアツバン タソウ ヨウセツ ツギテ ニ オケル ナイブ ザンリュウ オウリョク ケイソク ノ セイド ケンショウ

この論文をさがす

抄録

In this study, semi-destructive methods of conventional deep hole drilling (DHD) and incremental DHD (iDHD) techniques and destructive method using strain gauge were applied, respectively, to measure through-thickness residual stress in multi-pass welded joints of 100mm thick plate. Meanwhile, welding thermal elastic-plastic analysis with the finite element methods was performed to calculate the distribution of residual stress in the multi-pass welded joints. The calculated weld penetration, temperature profiles and through-thickness residual stresses in the welds were compared, respectively, with those measured. Through the comparison among them, the applicability and measurement accuracy of conventional and incremental DHD techniques for the welds were discussed. The results showed that the applicability of both DHD techniques was not too bad to estimate the distribution of residual stress induced by welding. In particular, the iDHD technique showed better accuracy of measurement of through-thickness residual stress in the welds, even though it takes more time and effort for measurement process. A reasonable balance of accuracy and effort might have to be taken into consideration for the application of DHD techniques for the welds.

収録刊行物

  • 圧力技術

    圧力技術 57 (3), 162-170, 2019

    一般社団法人 日本高圧力技術協会

詳細情報 詳細情報について

問題の指摘

ページトップへ