-
- GOTO Akihiro
- Department of Mechanical Engineering, Shizuoka Institute of Science and Technology
-
- DOHI Minoru
- Department of Electrical and Electronic Engineering, Shizuoka Institute of Science and Technology
-
- FUJIWARA Hiroshi
- Department of Mechanical Engineering, Shizuoka Institute of Science and Technology
この論文をさがす
説明
<p>In this study, the transfer of insulating material from an electrode to a workpiece with discharge pulses was investigated. A method of transferring a conductive material has already been developed. However, for an insulating material, it is necessary to transform it into conductive electrode to allow discharge. In this report, zinc was used to bind the insulating material in order to form the electrode, and the zinc also works as a medium to transfer the insulating material during discharges. for the transfer of the insulating material as well as the binder of the electrode. It was expected that heat generated by discharges vaporizes all zinc elements and only the insulating material would remain on the surface of the workpiece. In fact, however, it was difficult to remove those zinc elements and a large amount of zinc remained in the layer. In this report, a method of reducing the elements of zinc from the layer was investigated.</p>
収録刊行物
-
- International Journal of Electrical Machining
-
International Journal of Electrical Machining 24 (0), 1-6, 2019
一般社団法人 電気加工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390283659839741440
-
- NII論文ID
- 130007785646
-
- NII書誌ID
- AN10564586
-
- ISSN
- 21885117
- 13417908
-
- NDL書誌ID
- 029680756
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可