3Dプリンティング技術に基づく自動車のシャシー用部品のトポロジー最適化構造の作製および加振試験による実験的評価

DOI オープンアクセス

書誌事項

タイトル別名
  • Fabrication of topology optimization structure for the automobile’s chassis parts based on 3D printing technology and experimental evaluation by vibration tests

抄録

In this paper, we present the result of vibration test using the automobile chassis parts fabricated by 3D printer based on the topology optimization results. In the topology optimization analysis, the strain energy minimization analysis was carried out, and the optimized shapes were obtained by changing the initial density conditions. The shapes were fabricated by 3D printer, and the practical vibration tests were performed. Consequently, it was found that same tendency can be obtained between numerical and experimental results.

収録刊行物

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

  • CRID
    1390283659848202112
  • NII論文ID
    130007793482
  • DOI
    10.24806/rrnitnc.55.0_21
  • ISSN
    24323241
    00277568
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • CiNii Articles
    • KAKEN
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ