縦壁に段差を有する自動車用パネル部材のホットスタンプ工法の開発

DOI DOI Web Site Web Site Web Site ほか1件をすべて表示 一部だけ表示 被引用文献1件 参考文献8件 オープンアクセス

書誌事項

タイトル別名
  • Development of Hot Stamping for Automotive Panel Parts with Step-shaped Wall
  • タテヘキ ニ ダンサ オ ユウスル ジドウシャヨウ パネル ブザイ ノ ホットスタンプ コウホウ ノ カイハツ

この論文をさがす

説明

<p>We developed a hot stamping method for panel parts with a step-shaped wall. The die-set for the developed method divides the punch at a step-shaped wall into an outer punch and an inner punch. The outer punch is placed first. In addition, an opening is added to the blank of the developed method. The developed method makes it possible to change the main forming type from draw forming to cylindrical stretch flange forming in the middle of a forming stroke. The stretch flange forming can prevent a fall in temperature at a hole edge, because the hole edge does not come into contact with the die-set during forming and because the high ductility of high-temperature materials can be used, making it advantageous for hot stamping. If the preceding amount of the outer punch is large with the developed method, the effect of suppressing wrinkles is large but the sheet thickness reduction that can cause cracking rises. If the preceding amount of the outer punch is small, the rate of sheet thickness reduction ratio is greatly restrained, but the wrinkles become larger. By setting an appropriate preceding amount of the outer punch with the developed method, forming without cracks or wrinkles is possible.</p>

収録刊行物

  • 塑性と加工

    塑性と加工 61 (710), 75-80, 2020

    一般社団法人 日本塑性加工学会

被引用文献 (1)*注記

もっと見る

参考文献 (8)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ