Method of implementing radiation resistance to analysis model for radiated emission using chain parameter matrix
-
- Kuwabara Nobuo
- Department of Electrical and Electronic Engineering, Kyushu Institute of Technology
-
- Matsushima Tohlu
- Department of Electrical and Electronic Engineering, Kyushu Institute of Technology
-
- Fukumoto Yuki
- Department of Electrical and Electronic Engineering, Kyushu Institute of Technology
Abstract
<p>The analysis method using the chain parameter matrix (F-matrix) has been proposed for calculating radiated emission from the cable used by power line communication (PLC). In this paper, the radiation resistance was implemented to the F-matrix as the load of the common mode current which was converted from the differential mode PLC signal by the unbalance of the transmission system and was considered as the emission source. The calculated result for the simple cable model was compared to the measurement value and to the calculation value of which the radiation resistance was not considered. The investigation result indicated that the influence of radiation resistance appeared at the frequency where the high radiated emission was observed.</p>
Journal
-
- IEICE Communications Express
-
IEICE Communications Express 9 (9), 446-450, 2020-09-01
The Institute of Electronics, Information and Communication Engineers
- Tweet
Details
-
- CRID
- 1390285300187238272
-
- NII Article ID
- 130007895332
-
- ISSN
- 21870136
-
- Text Lang
- en
-
- Data Source
-
- JaLC
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed