Method of implementing radiation resistance to analysis model for radiated emission using chain parameter matrix

DOI Web Site 参考文献3件 オープンアクセス
  • Kuwabara Nobuo
    Department of Electrical and Electronic Engineering, Kyushu Institute of Technology
  • Matsushima Tohlu
    Department of Electrical and Electronic Engineering, Kyushu Institute of Technology
  • Fukumoto Yuki
    Department of Electrical and Electronic Engineering, Kyushu Institute of Technology

説明

<p>The analysis method using the chain parameter matrix (F-matrix) has been proposed for calculating radiated emission from the cable used by power line communication (PLC). In this paper, the radiation resistance was implemented to the F-matrix as the load of the common mode current which was converted from the differential mode PLC signal by the unbalance of the transmission system and was considered as the emission source. The calculated result for the simple cable model was compared to the measurement value and to the calculation value of which the radiation resistance was not considered. The investigation result indicated that the influence of radiation resistance appeared at the frequency where the high radiated emission was observed.</p>

収録刊行物

参考文献 (3)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ