Formation mechanism of texture in α-alumina coatings produced by aerosol deposition

DOI Web Site 被引用文献1件 参考文献5件
  • HASEGAWA Makoto
    Division of Systems Research, Faculty of Engineering, Yokohama National University
  • KOMURO Masahiro
    Department of Systems Integration, Graduate School of Engineering, Yokohama National University
  • KIMURA Kyonosuke
    Department of Systems Integration, Graduate School of Engineering, Yokohama National University
  • HASHIMOTO Soma
    Department of Mechanical Engineering, Materials Science, and Ocean Engineering, Graduate School of Engineering Science, Yokohama National University
  • TANAKA Makoto
    Japan Fine Ceramics Center
  • KITAOKA Satoshi
    Japan Fine Ceramics Center
  • KAGAWA Yutaka
    Katayanagi Advanced Research Lab., Tokyo University of Technology

抄録

<p>To investigate the texture formation mechanism in aerosol deposition (AD), coatings were deposited under various conditions using pure α-Al2O3 powder particles. The deposition rate increased with increasing gas flow rate when the gas flow rate was in the range from 6 to 30 L/min. Furthermore, the deposition rate increased with increasing substrate heating temperature. No large difference in the microstructure of the α-Al2O3 coating was observed. The formed α-Al2O3 coatings was fully dense and crystalline. X-ray diffraction analysis of the coating surfaces revealed specific textures. A texture with (0001) planes tilted approximately 15° from the coating plane was detected in the as-deposited specimen at a nozzle angle of 90°. Whether the nozzle angle was 90 and 60°, almost the same texture was formed indicating that the shear force does not contribute to texture formation. Texture formation was due to plastic deformation of the α-Al2O3 powder during collisions with the substrate. This is thought to be due to activation of basal and pyramidal slip systems. When the substrate was heated during AD, the texture changed to a (0001) fiber texture where the (0001) planes were parallel to the coating surface. The change in texture during substrate heating can be explained by a change in the critical resolved shear stress for the slip systems. The authors have previously reported that (0001) fiber texture has formed when the specimen was heat treated after the coating was deposited at room temperature. However, the mechanism of (0001) fiber texture formation by heat treatment is different form this research. During heat treatment, the texture is formed by the preferential growth of grains having (0001) plane at the surface of the coating.</p>

収録刊行物

被引用文献 (1)*注記

もっと見る

参考文献 (5)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ